Ingalls 93028 - Manual (Page 2)

© Ingalls Engineering Co., Inc. ● 2011 Cherry Street, Suite 104 ● Louisville CO 80027
(800) 641-9795 ● (303) 665-7800 ● Fax: (303) 665-7810 ● www.ingallseng.com
in order to help lessen vibration. If your brackets are within these measurements and Parallel, torque the bolts
removed in steps 3 and 5 to manufactures specs. Thread lock can be used in this step.
8. Adjust engine torque damper for proper length there should be no binding between the bracket and the heim joint
on the engine torque damper. Refer to Illustration 4 for proper engine torque damper placement. Use supplied
hardware to install the damper onto the brackets. The order should go bolt/damper/rubber o ring/bracket/nut. Check
once more for any binding in the brackets or torque damper, if everything matches Illustration 4, torque the
supplied (17 mm socket and 15 mm socket) M10 hardware to 35 Ft. pounds. If your gap between the brackets is
>16 mm use 1 M10 washer as needed to align the E.T.D. with the brackets.
9. Check to make sure all bolts and nuts have been torqued to specifications that were provided in the kit or by your
vehicle manufacturer. Re-install the power steering reservoir removed in step 6 and the coolant overflow tank
removed in step 2. Be careful to route all hoses away from the engine torque damper and all moving parts.
Illustration 1 Illustration 2 Illustration 3 Illustration 4
Note: Proper use and fitment of the rubber O-ring helps dampen additional road noise or road “feel” that can be
transferred through the damper assembly. The o-ring should be used between the Stiffy™ rod end and bracket for
optimal noise dampening. Dynamat or other dampening materials as used in the aftermarket stereo and in-car
electronics industries can also be used to provide further noise and vibration dampening.
Limited Warranty
Subject to Disclaimer. All Ingalls products are warranted against defects in materials and workmanship for ninety (90) days from date of purchase. During the
warranty period, Ingalls will repair, or at its option replace at no charge, components that prove to be defective. The product must be returned, shipping prepaid, to
Ingalls facility. This limited warranty does not apply if the product is damaged by accident or misuse. The foregoing warranty is in lieu of all other warranties
expressed or implied including but not limited to any implied warranty of merchantability, fitness, or adequacy for any particular purpose or use. Ingalls shall not be
liable for any special, incidental or consequential damages whether in contract, tort, or otherwise resulting from the use or the inability to use the product.
Warranty Disclaimer
Use of this product in competition, or use on vehicles altered from original manufacturer’s specifications or settings, EXPRESSLY VOIDS WARRANTY. The user is
urged to inspect for suspension binding or interference when the product is used in these manners. However, due to the varying conditions and manner of use
which the product will be subjected to in such uses, Ingalls Engineering Co., Inc. makes no warranties, either express or implied, including any warranty of
merchantability or fitness for a particular purpose for use in competition or with specifications or settings other than those specified by the original manufacturer’s
specifications.
The Stiffy™ Engine Torque Damper
For more information on adjusting the Stiffy™ for your specific application,
please visit www.ingallseng.com and click on the Stiffy™ page.