Ingalls 93039 - Manual (Page 2)

© Ingalls Engineering Co., Inc. ● 2011 Cherry Street, Suite 104 ● Louisville CO 80027
(800) 641-9795 ● (303) 665-7800 ● Fax: (303) 665-7810 ● www.ingallseng.com
4. Place the supplied spacer sleeve between both sides of the Engine Mounting Bracket. Install Stiffy™ on the Engine
Mounting Bracket with the extension facing the Chassis Mounting Bracket. Use the supplied M10x1.50x70mm bolt, o-ring,
washer and locking nut (black in color). The bolt goes through the Stiffy™ rod end then the o-ring, washer and finally
through the bracket and spacer. Tighten nut on rear of bolt. Refer to Illustration 4.
5. Adjust length of the Stiffy™ at the Engine Mounting Bracket rod end to align holes at the Chassis Mounting Bracket.
6. Use the supplied M10x1.50x15mm bolt and hardware to install the Stiffy™ to the rear side of the Chassis Mounting Bracket
similar to step 4 above, utilizing the provided o-ring and washer between the rod end and the bracket. Refer to Illustration
5.
7. Reinstall engine cover. Check for clearance between Stiffy™ and engine cover. Some trimming of the cover may be
necessary.
Note: The flat washers and o-rings must be used on the Stiffy™ mounting bolts between the bracket and rod end to prevent
the rod end from vibrating against the bracket. The flat washer goes toward the bracket and the o-ring goes toward the rod end.
Illustration 1 Illustration 2 Illustration 3
Illustration 4 Illustration 5
Note: Do not attempt to adjust Stiffy™ from its pre-set stiffness without consulting the Ingalls website. Large open-
end wrenches are required to adjust stiffness. Most standard and mechanics tool kits do not include these types of
wrenches.