Ingalls 35300 - Manual

Installation Instructions
1. Record and document initial reading alignment readings.
2. Raise vehicle and remove wheel.
3. Mark position of original cam bolt.
NOTE: Replace one cam bolt assembly at a time.
4.
Remove nut, washer and cam bolt.
5. Install new cam bolt in the same position as old bolt.
6. Install new nut and washer and tighten slightly.
7. Repeat steps 3 thru 8 for other cam bolt assembly.
8. Lower vehicle and continue with alignment.
9. Check and adjust toe.
ING3530-72897
Copyright © 1997-04 Ingalls Engineering Co., Inc.
CHEVROLET CORVETTE (REAR)
Cam bolt assembly
located on upper
control arm at inside
mount.
Replace one bolt at
a time.
CHRYSLER PRODUCTS
CAM BOLT
Cam bolt assembly located on lower control arm at inside mount.
FORD PRODUCTS
To release spring
tension place a
wedge between the
upper control arm
and the front cross
member