Knape&Vogt BYP-75S Series - Manual (Page 3)

4
HANG DOORS
• Open quick release latches on brackets.
• Slide door onto carrier screws and close latch.
• Repeat for front door on front rail.
SLIDING DOOR HARDWARE - BY PASS
Assembly
Instructions
#310323_A (0912)
5
ADJUST AND FINISH
• Adjust door to square with sides of door opening by rotating carrier adjustment screw.
• Install door guide where doors overlap. Use (#8 x 1-1/2") screws
to secure to door.
• Mount door stop to inside surface
of front door. Place door stop
so that the front door does not
cover rear door pull when
opened. Use (#8 x 3/4") screws.