KIA Magentis 2006 - Manual (Page 125)

DRIVING YOUR VEHICLE
4-46
SYSTEM OPERATION
VENTILATION
1. Set the mode selection switch to the
position.
2. Set the air intake control switch to
the outside air position.
3. Set the temperature control knob to
the desired position.
4. Set the fan speed control knob to the
desired speed.
HEATING
1. Set the mode selection switch to the
position.
2. Set the air intake control switch to
the outside air position.
3. Set the temperature control knob to
the desired position.
4. Set the fan speed control knob to the
desired speed.
5. If dehumidified heating is desired,
turn the air conditioning system (if
equipped) ON.
• If cool air is desired at face level for
bi-level operation, set the mode
selection switch to the position.
• If the windshield fogs up, set the mode
selection switch to the position.
AIR CONDITIONING
SYSTEM OPERATING
TIPS:
• If the vehicle has been parked in
direct sunlight during hot weather,
open the windows for a short time to
let hot air inside the vehicle escape.
• To help reduce moisture on the inside
of windows on rainy, humid days,
decrease the humidity inside the
vehicle by operating the air
conditioning system.
• During air conditioning system
operation, you may occasionally
notice a slight change in engine
speed at idle as the A/C compressor
cycles ON. This is a normal system
operating characteristic.
• Use the air conditioning system every
month if only for a few minutes.
• After air conditioning system use,
you may notice clear water dripping
(or even puddling) on the ground
under the passenger side of the
vehicle. This is a normal system
operating characteristic.
CAUTION
Continued climate control system
operation in the recirculated air
position may allow humidity to
increase inside the vehicle which
may fog the glass and obscure visi-
bility.
MS-CNA-Eng 4(40~).QXD 7/25/2005 5:15 PM Page 46