KIA Magentis 2006 - Manual (Page 151)

5-15
Erasing Programmed Buttons
To erase the three HomeLink buttons,
press and hold the two outside buttons
until the indicator light begins to flash
(after 20 seconds). Release both buttons.
Individual buttons cannot be erased, but
can be reprogrammed.
Reprogramming a Single
HomeLink Button
To program a device to HomeLink using
a HomeLink button previously trained,
follow these steps:
1. Press and hold the desired HomeLink
button. Do not release until step 4 has
been completed.
2. When the indicator light begins to
flash slowly (after 20 seconds), hold
the handheld transmitter 1 to 3 inches
away from the bottom of the mirror.
3. Press and hold the transmitter button
(or, if necessary, press and "cycle,"
as described in the ‘"Gate Operator
& Canadian Programming" portion
of this text).
4. The HomeLink indicator light will
flash slowly at first, then rapidly,
indicating successful programming.
Release both buttons.
Gate Operator Programming &
Canadian Programming
During programming, your hand-held
transmitter may automatically stop
transmitting.
Continue to press and hold the
HomeLink button while you press and
repress ("cycle") your handheld
transmitter every two seconds until the
frequency signal has been learned. The
indicator light will flash slowly at first
and then rapidly upon successful
training.
ACCESSORIES
For more information on HomeLink and
HomeLink-compatible products, or to
purchase HomeLink accessories, call
1.800.355.3515 or visit
www.homelink.com.
MMSA5005
Flashing
MS-CNA-Eng 5 New.qxd 7/25/2005 5:21 PM Page 15