Newport Brass 3-1686 Virginia - Manual (Page 2)

Rough in valve Installation
Recommended Installation by a Professional Plumbing Contractor
Note: Use plumbers tape or equivalent to seal all threaded joints.
Warning: To prevent severe damage to valve body, any solder/braze process must be per-
formed a min. of 4" from ports.
1. Install the quick connect spout shank through center hole of mounting surface. Secure with
washer nut.
(See Fig. 1)
2. Place washer nut on valve body. Insert body, (blue cold & red hot), through hole from
below mounting surface. See Fig. 1. Adjust and secure with additional washer nut so that the
top of valve stem is at the correct height from mounting surface. (See Fig. 1 )
Fig. 1
Spout nipple to
be used with
trim installation
2 7/8
Finished Deck
Washer Nut
Deck Flange
Washer Nut
3. Attach hot/cold valves to spout, utilizing ¾" copper pipe. (See Fig. 2)
NWP1-547
Fig. 2
Inlet for hot
water supply
Inlet for cold
water supply