Newport Brass 3-1686 Virginia - Manual (Page 3)

Trim Installation
Note: To achieve desired handle rotational alignment, the cartridge MUST be tightened in a clockwise rotation
only.
The use of petroleum base plumbers putty on our products will nullify the warranty. We recommend the use of
clear silicone sealing materials.
(Cartridge Bonnet factory torque is 14-16 ft-lbs.)
1. Attach handle trim to valve. When possible, any adjustments for rotational alignment should be made to the
valve body - not to the cartridge. (Note: Allow minimum spacing between handles and escutcheon/bonnet to
prevent damage to the surface finish.) Secure handles into place with setscrew. (See Fig. 3)
2. Apply plumbers tape to spout nipple and install into base of spout. Slide spout nipple into quick connect
deck flange (re-grease if necessary). Make sure spout is flush with deck and secure into place with setscrew.
(See Fig. 3)
3. Turn on water supply, check for leaks and make any final adjustments required.
** Optional item based on model selected
Fig. 3
Handle
Bonnet**
Escutcheon**
Valve
Quick connect
Deck flange
Spout nipple
w/ O-rings
Spout
Set
Screw
(949)417-5207
NWP-1-547 Santa Ana, Ca. 92705 9/16/2011
www.brasstech.com