Derale Performance Stack Plate Cooler 4 Way Mount Bracket Kit - Manual

50020-InstructionSheet
INSTALLATION INSTRUCTIONS
REMOTE COOLER INSTALL KIT
PART # 50020
KIT CONTENTS
QTY. DESCRIPTION
4 Mounting Brackets
16 1/4”-20 x 3/4” Hex Bolt
40 1/4” Washer
16 1/4”-20 Lock Nut
TOOLS NEEDED
7/16” Socket & Ratchet
7/16” Open End Wrench
Drill
5/32” Drill Bit
Please read these instructions completely before starting the installation.
Warning: Installation of accessories should only be undertaken by those with mechanical knowledge and are familiar with working on
vehicles. Always use eye protection (goggles, safety glasses or shield). Park the vehicle in a well lit area, on level ground and apply the
parking brake. Only work on a cold vehicle that has been sitting overnight, failure to do so will result in severe burns and injury. Before starting
the vehicle, make sure no tools or any other items are left under hood that could interfere with or be drawn into moving parts of the engine.
Failure to follow instructions can lead to severe damage and personal injury.
Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com
The Cooler can be mounted in multiple locations on your vehicle. Reference
Diagram # 1 for possible cooler positions. #1 is the ideal location, #2 is second
best and #4 being the last choice.
Diagram #1
COOLER LOCATION
When selecting the best location for your vehicle, always consider a location
that will deliver the maximum airflow. (See Diagram #1)
BRACKET INSTALLATION
This bracket system is designed to work with Derale Stacked Plate Oil Coolers,
although they can be used for any application that applies.
1. Using the 1/4-20 x 3/4” Bolts, 1/4” Washers & 1/4” Lock Nuts supplied, choose the best mounting option for your
application and attach the four Mounting Brackets to the Oil Cooler in the desired locations. (See Diagram #2)
2. Holding the Oil Cooler in place, mark and drill eight 5/32” holes.
3. Using the 1/4-20 x 3/4” Bolts, 1/4” Washers & 1/4” Lock Nuts supplied, attach the Oil Cooler to the vehicle making
sure the Oil Cooler is not making contact with any moving parts or Hot engine components.
IMPORTANT
In most cases a rigid mount is sufficient as shown in
Diagram #2. For off road and extreme applications, we
recommend installing rubber isolators between the Oil
Cooler and the Brackets.
IMPORTANT
Diagram #2
Option 1 Option 2