Derale Performance Single Mount Universal Oil Filter Relocation Kit, 1_2" NPT Side Ports, 3__4-16 Filter Thread" - Manual (Page 2)

Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com
Warning: Installation of accessories should only be undertaken by those with mechanical knowledge and are familiar with working on
vehicles. Always use eye protection (goggles, safety glasses or shield). Park the vehicle in a well lit area, on level ground and apply the
parking brake. Only work on a cold vehicle that has been sitting overnight, failure to do so will result in severe burns and injury. Before starting
the vehicle, make sure no tools or any other items are left under hood that could interfere with or be drawn into moving parts of the engine.
Failure to follow instructions can lead to severe damage and personal injury.
BRAND PART #
AC
Fram
Motorcraft
Purolator
PF2
PH8A
FL1A
PER1A
OIL FILTER CHART
(Page 2)
FILTER MOUNT INSTALLATION
1. Choose a convenient location for the Ports-Up Filter Mount.
Make sure there is enough space for future servicing of the
oil filter. Suggested Locations: Firewall, Radiator Support,
Fender well.
2. Take the 3/4-16 Filter Nipple supplied, making sure the
shorter end of threads is installed onto the Filter Mount.
3. Using the filter mount as a template, mark and drill three
3/16” holes.
4. Using the #14 Sheet Metal Screws provided, install the
Ports-Up Filter Mount onto the vehicle.
The new Filter Mount is designed to accept a 3/4-16
oil filter Use Derale Part # 13092 or reference Oil
Filter Chart above for manufacturers part numbers.
Important:
.
HOSE ROUTING
1. Using the Hose Clamps provided, attach both ends of the 1/2”
Hose provided to the hose barbs on the installed Spin-On
Adapter forming a loop. (Apply a thin coat of oil to the Hose
Barbs so the hose slips on easily.)
2. Carefully route hose over to the Filter Mount.
Keep hoses away from sharp edges, moving parts and
exhaust. Do not bend hose sharper than a 5” radius.
3. Cut the hose to the proper length.
4. Using the Hose Clamps provided, attach the hose coming from
the OUT on the Spin-On Adapter to the IN on the Filter Mount.
5. Using the Hose Clamps provided, attach the hose coming from
the IN on the Spin-On Adapter to the OUT on the Filter Mount.
6. Apply a light coat of oil onto the o-ring of your new oil filter and
install on the filter mount.
1. Start the engine and quickly check all connections for leaks.
2. Turn-off the engine and check the oil.
3. Add oil as needed.
Note:
VEHICLE TESTING
Diagram #4
SPIN-ON ADAPTER INSTALLATION
1. Apply a light coat of oil onto the O-ring(s).
2. Take the O-ring and install into the groove on the Spin-On Adapter and Adapter Plate (if used).
3. Install onto the engine. (See Diagram #2)
4. Hand Tighten with the same force used in tightening a factory oil filter.
Diagram #3 Diagram #3