Operation, Control panel – Zanussi ZFC627WAP User Manual

Page 37

Advertising
background image

Environment Protection

This appliance does not contain gasses which

could damage the ozone layer, in either its refrig-

erant circuit or insulation materials. The appliance shall

not be discarded together with the urban refuse and

rubbish. The insulation foam contains flammable gases:

the appliance shall be disposed according to the appli-

cable regulations to obtain from your local authorities.

Avoid damaging the cooling unit, especially at the rear

near the heat exchanger. The materials used on this ap-
pliance marked by the symbol are recyclable.

Operation

Switching on

Insert the plug into the wall socket.

The Pilot light will light up.

Turn the Temperature regulator clockwise.
Important! If the temperature inside the appliance is too

high the Alarm light will light up.

Switching off

To turn off the appliance, turn the Temperature regulator

to the OFF position.

Temperature regulation

The temperature is automatically regulated.

To operate the appliance, proceed as follows:
• turn the Temperature regulator towards to obtain

the minimum coldness.

• turn the Temperature regulator towards to obtain

the maximum coldness.

A medium setting is generally the most suitable.

However, the exact setting should be chosen keeping in

mind that the temperature inside the appliance depends

on:
• room temperature
• how often the lid is opened
• the quantity of food stored
• the location of the appliance.

Control panel

1

2

3

4

5

1

Pilot light

2

High temperature alarm light

3

Fast Freezing light

4

Fast Freezing switch

5

Temperature regulator

Fast Freezing function

You can activate the Fast Freezing function by pressing

the Fast Freezing switch.

The Fast Freezing light will light up.

It is possible to deactivate the function at any time by

pressing the Fast Freezing switch. The Fast Freezing

light will switch off.

High temperature alarm

An increase in the temperature in the freezer (for exam-

ple due to an power failure) is indicated by switching on

of the Alarm light

During the alarm phase, don't place food inside the

freezer.

When normal conditions are restored the Alarm light

will switch off automatically.

37

Advertising