Hotpoint Ariston MH 99.1 IX-HA S - Manual (Page 21)

GB
21
Installation
! Please keep this instruction booklet in a safe place for future
reference. If the appliance is sold, given away or moved, please
make sure the booklet is also passed on to the new owners
so that they may benefit from the advice contained within it.
! Please read this instruction manual carefully: it contains
important information concerning the safe operation,
installation and maintenance of the appliance.
Positioning
! Do not let children play with the packaging material; it
should be disposed of in accordance with local separated
waste collection standards (see Precautions and tips).
! The appliance must be installed by a qualified professional in
accordance with the instructions provided. Incorrect installation
may damage property or cause harm to people or animals.
Built-in appliances
To ensure the proper working order of the built-in appliance,
the kitchen unit must be of a suitable size.
The sizes of the unit for installing the cooker under a worktop
or in a column unit are shown in figure.
min. 45 mm.
To provide adequate ventilation, there must be appropriate
ventilation openings in the front bottom and the top part of
the cabinet (an intake opening on the bottom of at least 200
cm2, and an exhaust opening of at least 90 cm2). The unit
panels next to the cooker must be heat resistant. In the case of
veneered wood units, glues must be resistant to a temperature
of 120 °C. In accordance with safety standards, once the
appliance has been mounted, there must be no possible
contact with electrical parts. Any protective parts must be
secured so that they can only be removed with the use of tools.
Fastening the oven
Insert the appliance into the compartment; open the oven
door and fasten the oven to the cabinet using the four screws
“A”, remembering to place the special spacers provided
between the hole and the screw itself.
447
mm
78
78
min.
550 m
m 52
47
2 m
m
47
5 m
m
860
mm
22 m
m
895
mm
525
mm
469
m
m
850
mm
Electrical connection
Those ovens equipped with a three-pole power supply cable
are designed to operate with an alternating current with the
voltage and frequency indicated on the data plate (located
on the appliance) and in the instruction manual. The wire
for earthing the appliance is yellow-green in colour.
Replacing the cable
Use a rubber cable of the type H05VV-F with a suitable
cross section 3 x 1.5 mm².
The yellow-green earth wire must be 2-3 cm longer than
the other wires.
Opening the terminal board:
• Using a screwdriver, prise on the side tabs of the terminal
board cover;
• Pull open the cover of the terminal board.
To install the cable, proceed as follows:
• Remove the wire clamp screw and the three contact
screws L-N-
• Fasten the wires beneath the screwheads using the
following colour scheme: Blue (N) Brown (L) Yellow-
Green
• Fasten the supply cable in place with the clamp and close
the cover of the terminal board.
N L