S&B Filters Cold Air Intake Kit - Cotton Filter 75-1514-1 - Manual (Page 2)

1/9/2009
REV-C
INSTALLATION INSTRUCTIONS
(continued)
13. Attach the S&B 1/2”x9” CCV hose to the tube. At-
tach the other end to the crankcase vent fitting on the
valve cover. Tighten the S&B intake tube connection
at the throttle body, and check all mounting points and
hose clamps for fit and tightness.
15. Attach the S&B air box lid to the S&B air box. Use the
#10 screws and washers.
Note: this kit is equipped with a clear lid.
16. Place the 3/4” spacer under the core support rod
and using the M8x40mm bolt and washer secure the
rod to the vehicle. Reconnect the negative side of the
battery.
Testing & Warranty Info:
1. Engage parking brake and start your
engine. To ensure that the system was in-
stalled properly, listen for abnormal noises. If
an air leak is detected, re-inspect hoses and
connections as they may need to be tight-
ened.
2. We recommend that you keep your stock
(OEM) intake system in the event that is
required in the future.
3. In order to maintain proper warranty, all
connections and components must be
checked periodically for alignment, re-
tightening of all the connections and clean-
ing. Failure to do so may void your warranty.
4. We recommend that you only use S&B
oil and cleaner products to service your filter.
Using any other manufacturer’s products
may void your warranty.
Smog Certification Note:
The California Air Resource Board
(CARB) requires that an E.O. identifi-
cation label be applied to the vehicle in
order to pass a smog check inspection
when installing a High Performance
Intake Kit.
You must place the E.O. label pro-
vided on or near the intake kit after
installation so that the smog technician
can easily verify the O.E. number dur-
ing the smog certification process.
S&B’S Precision Cleaning & Oiling Kit allows vehicle owners to
properly maintain their high performance air filters by precisely
applying the correct amount of oil. The clearly marked bottle and
easy-to-use applicator allow the user to measure and apply the
proper amount of oil for each application. S&B has conducted ex-
tensive testing with the Precision Cleaning Kit to ensure that it can
be used on most cotton high performance filters available today.
Part No. 88-0005
Order online today at www.sbfilters.com
or though your local S&B Distributor
787 S. Wanamaker Ave, Ontario, CA 91761
(909) 947-0015 Phone • (909) 947-0603 Fax
www.sbfilters.com
RESTORE YOUR HIGH PERFORMANCE FILTER
If Equipped: Remove the o-ring from the Air Temp. sen-
sor before inserting the sensor into the grommet in the
in-
take