S&B Filters Cold Air Intake Kit - Cotton Filter 75-1511-1 - Manual

4/26/2007
(909) 947 -0015 PHONE • (909) 947-0603 FAX
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS
(OVER)
Part # 75-1511-1
DODGE
RAM 5.2L & 5.9L
* Kit may not fit vehicles with body
lift installed.
QTY PARTS LIST QTY PARTS LIST (continued)
1 Intake Tube 2 Rivet Style Jack Nuts
1 Intake Box 4 #10 Sealing Washers
1 Intake Box Lid 4 SS Pan Head Screws
1 CARB Sticker 1 Air Filter
1 Throttle Body Gasket
1 “S” Bolt
2 #10-24 Pan Head Screws
2 #10 Flat Washers
2 1/4” - 20 Nylock Nuts
1 1/4” Fender Washer
1 1/2” x 26” L Hose
TOOLS REQUIRED
Flat Head Screw Driver
Phillips Head Screw Driver
Pliers
3/8” Socket or Wrench
1. With the ignition switched off, discon-
nect the negative battery cable. Loose
the air cleaner hose clamp from the
throttle body.
2. Disconnect the crank case vent line
from the OEM air cleaner housing.
3. Remove the air cleaner and intake tube
assembly by pulling up and towards
the center of the vehicle to detach the
tube from the inner fender well. Re-
move the stock throttle body gasket as
well.
4. Install the supplied gasket to the throttle
body.
5. Thread the supplied “S” bolt into the
throttle body until tight, and back off
one full turn.
6.
Locate two (2) holes on passenger side
fender well.
7. A) Insert jack nuts into holes in fender
well and tighten #10-24 screws into
the jack nut while holding the jack nut
tight with pliers.
7) B) Repeat step for second nuts and
remove the #10-24 screws from the rivet
nuts. You will use these screws later to
install the intake box.
9. Insert the intake tube into air box first,
then rotate the intake tube over the “S”
bolt in the throttle body.
10. Adjust the air tube until it seats com-
pletely over the throttle body and rests on
the supplied gasket.
8. Install the intake box on to fenderwell
and secure using the supplied #10-24
screws and 1/4” washers.