S&B Filters Cold Air Intake Kit - Cotton Filter 75-3030-1 - Manual (Page 2)

5/23/2008
REV-B
PERFORMANCE TESTING
1. Engage parking brake and start
your engine. To ensure that the
system was installed properly, lis-
ten for abnormal noises. If an air
leak is detected, re-inspect hoses
and connections as they may need
to be tightened.
2. S&B FILTERS RECOMMENDS
THAT YOU KEEP YOUR OEM
INTAKE SYSTEM IN THE EVENT
IT IS REQUIRED IN THE FU-
TURE.
3. In order to maintain proper war-
ranty, all connections and compo-
nents must be checked periodically
for realignment and to tighten all
connections. Failure to do so will
void your warranty.
4. Use only S&B Cleaning and Oil
products to service your filter. Us-
ing another company’s oil and
cleaner products may void your
warranty.
787 S. Wanamaker Avenue, Ontario, CA 91761
(909) 947-0015 Phone • (909) 947-0603 Fax
www.sbfilters.com
INSTALLATION INSTRUCTIONS
(continued)
12. Attach the MAF sensor to the S&B air
box, position and tighten both clamps.
13. Attach the S&B hump adapter to the
MAF sensor and secure the hose clamp.
14. Attach 4” x 2” straight adapter to the
S&B air intake tube with a #64 hose clamp.
NOTE: On some models it may be
necessary to trim the fan shroud slightly to
allow clearance for the S&B air intake tube.
15. Install the S&B air intake tube and
tighten clamps on both ends. Tighten all
adapter hose clamps and the 4 bolts that
secure the S&B air box.
17. Install the S&B Air Filter and secure the
hose clamp.
18. Remove the protective covering then
install the clear lid using the supplied
hardware.
19. Reconnect the negative battery cable
and check your installation to make sure
everything is properly positioned and se-
16. Reconnect the MAF sensor electrical
connection.
Smog Certification Note:
The California Air Resource Board
(CARB) requires that an E.O.
identification label be applied to the
vehicle in order to pass a smog check
inspection when a High Performance
Intake Kit has been installed.
You must place the E.O. label provided
on or near the intake kit after installation
so that a smog check technician can
easily verify the E.O. number.
Part No. 88-0005
Order online today at www.sbfilters.com
or though your local S&B Distributor