S&B Filters Cold Air Intake Kit - Cotton Filter 75-3017-2 - Manual (Page 2)

1/16/2008
13. Remove the nut that holds the throttle cable
bracket.
14 Install the short coupling nut to the throttle
body stud.
15. Install the long coupling nuts (two each)
onto the other throttle body studs.
16. Install the gasket on the throttle body
flange.
17. Install the adapter using the three (3)
SHCS bolts provided, being careful not to over
tighten.
18. Install the 4 x 1 1/4” adapter sleeve over
the adapter and tighten using the hose clamp
provided in this kit.
19. Assemble the “L” bracket and saddle
bracket. Using the M6 hardware & nylon bushing.
22. Insert the 1” OD grommet into the existing
hole in the primary intake tube.
20. Install the saddle bracket assembly to the
factory air box mounting stud then tighten with
hardware provided in this kit.
23. Install the air temperature sensor into the
grommet. If needed, lubricate grommet with a
mild mix of soap and water to ease insertion.
21. Remove the mass air sensor from the fac-
tory intake tube and air box top. Remove the air
temp sensor from the factory tube.
24. Attach the adapter sleeve to the end of the
primary intake tube using the hose clamp provided
in this kit.
27. Install the S&B air filter onto the mass air
sensor and position saddle clamp against the
driver side of filter.
26. Install the primary intake tube to the adapter
and tighten the second hose clamp.
25. Attach the adapter sleeve to the mass air
sensor with the hose clamp provided in this kit.
28. Slide shield between upper radiator hose
and S&B air filter. Push shield flange against
S&B air filter neck. Wrap hose clamp around
shield flange and saddle bracket then tighten.
(See Photos A & B below)
A
B
29. Reconnect the mass air sensor plug.