S&B Filters Cold Air Intake Kit - Cotton Filter 75-5037 - Manual (Page 2)

6/13/2008
REV-D
13. Slide the S&B Hump Adapter (L) over the
filter adapter (K), center over the gap between
the tubes and secure the #72 and #64 Hose
Clamps (M).
14. Use the T-20 Security Torx Tool supplied
and remove the MAF Sensor from the OE air
box.
15. Peel the backing from the MAF Sensor
Gasket (H) before placing it over the sensor,
sticky side down.
18. Place the S&B Air Filter (C) into the S&B
Air Box (D), slide onto the flange and secure
the # 80 Hose Clamp (F).
17. Reconnect the MAF sensor electrical
connection.
19. Remove the protective covering from the
S&B Clear Lid (E).
20. Place the clear lid on the air box and
secure using the 8/32 SS Screws (A) and SS
Washers (B).
21. Reconnect both negative battery cables.
22. Inspect your installation, make sure kit is
properly positioned and all fasteners are tight.
PERFORMANCE TESTING
∗ Engage parking brake and start your
engine. Listen for abnormal noises. If an
air leak is detected, re-inspect hoses and
connections as they may need to be
repositioned and tightened.
∗ S&B FILTERS recommends that you
keep your OE intake system in the event
it is required in the future.
∗ In order to maintain your warranty, all
connections and components must be
checked periodically for alignment and
for proper tension on all connections.
Failure to do so may void your warranty.
∗ Use only S&B FILTERS cleaning and oil
products to service your filter. Using any
other brand oil and or cleaners on your
S&B air filter may void your warranty.
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS
(continued) (continued)
(909) 947-0015 Phone (909) 947-0603 FAX
www.sbfilters.com
16. Place the M4 screws (I) through the MAF
mounting holes, then place the Rubber Wash-
ers (G) over the screws. Insert the MAF sensor
into the S&B Filter Adapter (K) (note the direc-
tion of air flow) and tighten the M4 screws
evenly. Do Not Over Tighten!
Rubber Washer M4 Screw
Smog Certification Note:
The California Air Resource Board
(CARB) requires that an E.O.
identification label be applied to the
vehicle in order to pass a smog
check inspection when a High
Performance Intake Kit has been
installed.
You must place the E.O. label
provided on or near the intake kit
after installation so that a smog
check technician can easily verify
the E.O. number.