S&B Filters Cold Air Intake Kit - Cotton Filter 75-3035 - Manual (Page 2)

8/26/2008
REV-C
PERFORMANCE TESTING
∗
Engage parking brake and start your engine. To
ensure that the system was installed properly,
listen for abnormal noises. If an air leak is de-
tected, re-inspect hoses and connections as
they may need to be tightened.
∗
S&B FILTERS RECOMMENDS THAT YOU
KEEP YOUR OEM INTAKE SYSTEM IN THE
EVENT IT IS REQURIED IN THE FUTURE.
∗
In order to maintain proper warranty, all connec-
tions and components must be checked periodi-
cally for realignment and to tighten all connec-
tions. Failure to do so will void your warranty.
∗
Use only S&B cleaning and oil products to ser-
vice your filter. Using other company’s oil and
cleaner products may void your warranty.
Please call (909) 947-0015 should you have any
questions or comments.
(909) 947-0015 Telephone - (909) 947-0603 Fax
www.sbfilters.com
INSTALLATION INSTRUCTIONS
(continued)
10. Push the OE CCV hose end into the appropriate hole in
the S&B performance filter.
11. Attach the S&B filter to the MAF Sensor. Place the S&B
filter shield over the air filter and hose clamp them to-
gether.
12. Place the assembly into the vehicle. Using the 2 “L” brack-
ets mark the filter shield and OE plastic cover as shown,
with a scribe. You will use an “L” bracket on each side of
the shield. Remove and drill the marked holes with a 1/8
drill
13. Place the assembly back into the vehicle and secure the
hose clamps. Line up the 1/8” inch holes and “L” brackets
and use the four #10 sheet metal screws to secure the
assembly to the vehicle.
Part No. 88-0005
S&B’S Precision Cleaning & Oiling Kit allows vehicle
owners to properly maintain their high performance air
filters by precisely applying the correct amount of oil. The
clearly marked bottle and easy-to-use applicator allow the
user to measure and apply the proper amount of oil for each
application. S&B has conducted extensive testing with the
Precision Cleaning Kit to ensure that it can be used on most
cotton high performance filters available today.
15. Affix the C.A.R.B. exemption sticker in plain sight under the
hood near the intake system, the installation is now complete.
14. Reconnect the electrical connection for the MAF Sensor
and then reconnect the negative battery cable.
Smog Certification Note:
The California Air Resource Board
(CARB) requires that an E.O.
identification label be applied to the
vehicle in order to pass a smog
check inspection when a High
Performance Intake Kit has been
installed.
You must place the E.O. label
provided on or near the intake kit
after installation so that a smog
check technician can easily verify
the E.O. number.