S&B Filters Cold Air Intake Kit - Cotton Filter 75-5027 - Manual (Page 2)

6/9/2008
REV-B
PERFORMANCE TESTING
∗ Engage parking brake and start your
engine. Listen for abnormal noises. If an
air leak is detected, re-inspect hoses and
connections as they may need to be repo-
sitioned and tightened.
∗ S&B FILTERS RECOMMENDS THAT
YOU KEEP YOUR OEM INTAKE SYS-
TEM IN THE EVENT IT IS REQURIED IN
THE FUTURE.
∗ In order to maintain your warranty, all
connections and components must be
checked periodically for alignment and
for proper tension on all connections.
Failure to do so will void your warranty.
∗ Use only S&B Filter cleaning and oil prod-
ucts to service your filter. Using any other
brand oil and or cleaners may void your
warranty
.
(909) 947-0015 Phone • (909) 947-0603 Fax
www.sbfilters.com
INSTALLATION INSTRUCTIONS
(continued)
13. Attach the S&B air box adapter (H) to the
S&B air box (F), latch the bottom and use the
5/16 screws (G) to secure the top.
14. Place the S&B air box assembly in the
vehicle. Before seating the grommets,
reconnect the temp. sensor electrical connector.
15. When the S&B air box is in place, secure
using the OE nut and washer.
17. Reconnect the negative battery cable.
16. Center the S&B hump adapter (J) over
the gap between the tubes. Secure both
# 64 hose clamps (I).
18. Reinstall the OE air scoop and secure
with the OE bolt and washer.
20. Install the S&B clear lid (R), secure with
10/24 screws (S) and concave rubber footed
washers (U). Do not over tighten.
21. Inspect your installation, make sure kit is
properly positioned and all fasteners and
connections are tight.
1.
12. Slide the S&B hump adapter (J) with both
# 64 hose clamps (I), over the S&B air box
adapter (H) until flush with the end. 19. Install the S&B air filter (C) to the S&B air
box adapter (H), secure the # 72 hose clamp.
Smog Certification Note:
The California Air Resource Board
(CARB) requires that an E.O.
identification label be applied to the
vehicle in order to pass a smog
check inspection when a High
Performance Intake Kit has been
installed.
You must place the E.O. label
provided on or near the intake kit
after installation so that a smog
check technician can easily verify
the E.O. number.