S&B Filters Cold Air Intake Scoop AS-1009 - Manual (Page 2)

INSTALLATION INSTRUCTIONS
VEHICLE APPLICATION
Year: 2006-07
Make: Chevy (Only)
Model: Silverado 2500HD/3500
Engine: 6.6L LLY/LBZ Duramax
* Works only with kit #: 75-5013-1
OE CHEVY BUMPERS ONLY
NOTES
Kit may NOT fit with the following:
• Aftermarket Bumper
• Body Lift or Lowering Kit
• Front Hitch
• Oversized Wheels and Tires
15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbfilters.com
2.
Disconnect the MAF sensor wiring and
all hose clamps. Then remove your S&B (or
OE) intake kit from the truck.
5.
Install the Scoop Channel (A) taking the
place of the air box mounting tray. Install the
2 OE grommets in the larger holes. Mount up
top using the 3 M6x1.0x30mm Screws
(E)
and 6mm Washers (D) .
P/N: AS-1009
2
Important: Read warning page prior to proceeding.
BEFORE YOU START
• Please read the entire product guide before proceeding.
• Ensure all components listed on page 5 are present.
• If you are missing any of the components, call our customer support at (909) 947-0015.
• Do not work on your vehicle while engine is hot.
• Make sure the engine is turned off and the vehicle is in Park or the Parking Brake is set.
6.
Remove the two bolts from the bumper
support bracket using a 15mm socket. Install
the Scoop Mounting Bracket
(H) using the
same two bolts. Leave the bolts hand tight for
now.
7.
Install the 4 Speed nuts (F) by pushing
them down until they clip into the holes on the
Scoop Inlet
(B) .
TOOLS REQUIRED
• 3/8”, 1/2” Drive Ratchets and Extensions
• 7/16”, 10mm, 13mm, 15mm Sockets
• 10mm, 7/16” Wrenches
• Phillips and Flat Blade Screwdriver
3.
Loosen the 5 screws and remove the air
box mounting tray. Retain the two rubber
grommets to be used on the new scoop.
1. With the ignition switched off and the
parking brake set, disconnect the negative
battery cable on both batteries.
8.
Install the Scoop Inlet assembly up into
the Scoop Channel and secure using four
1/4-20x1.0” Screws
(G) and 6mm washers
(D) . Tighten all the mounting hardware when
you are satisfied with the position.
SEE EXPLODED VIEW ON PAGE 5
4.
Remove the wheel liner support plate by removing 3 fasteners. First remove the screw and
fastener from outside the wheel liner. The third fastener can be removed easier from inside the
engine compartment located on the inner fender.