S&B Filters Cold Air Intake Kit - Cotton Filter 75-5003 - Manual (Page 2)

2/1/2010
REV-D
PERFORMANCE TESTING
∗
Engage parking brake and start
your engine. Listen for abnormal
noises. If an air leak is detected,
re-inspect hoses and connections
as they may need to be reposi-
tioned and tightened.
∗ S&B FILTERS RECOMMENDS
THAT YOU KEEP YOUR OEM
INTAKE SYSTEM IN THE
EVENT IT IS REQURIED IN THE
FUTURE.
∗ In order to maintain your war-
ranty, all connections and com-
ponents must be checked peri-
odically for alignment and for
proper tension on all connec-
tions. Failure to do so will void
your warranty.
∗ Use only S&B Filter cleaning and
oil products to service your filter.
Using any other brand oil and or
cleaners may void your warranty.
(909) 947-0015 Phone • (909) 947-0603 Fax
www.sbfilters.com
INSTALLATION INSTRUCTIONS
(continued)
Order online today at www.sbfilters.com
or though your local S&B Distributor
Part No. 88-0005
13. Tighten the hose clamp and secure the
tube to the throttle Body.
14. Assemble the air box using the 5/16” hard-
ware. Take the stock grommets from step #9 put
them back in the fender before installing the box.
16. Insert the High Performance Air Filter into the
air box. Push the flange of the filter thru the hole
in the air box then slide the hose clamp over the
flange.
17. Place the air box assembly into the vehicle.
Slip the tube inside the filter and using the OE bolt
loosely attach the “L” bracket to the inner fender.
18. Secure the air filter to the tube by tightening
the hose clamp, then secure the air box “L”
bracket.
20. Connect the breather hose to the barb
located on the valve cover. Use the #8 hose
clamp to secure the hose to the barb.
19. Reconnect the MAF sensor electrical
connection.
21. Install the clear lid. Check all of the hardware
for proper fit, loosen up realign and secure all
fasteners if necessary.
22. Reconnect the negative battery terminal.
Smog Certification Note:
The California Air Resource Board
(CARB) requires that an E.O.
identification label be applied to the
vehicle in order to pass a smog check
inspection when a High Performance
Intake Kit has been installed.
You must place the E.O. label provided
on or near the intake kit after installation
so that a smog check technician can
easily verify the E.O. number.
15. Install the “L” bracket short side to the air
box, leave loose for adjustment.
Check that all tools have been removed from
the engine compartment. The installation is
now complete.