S&B Filters Cold Air Intake Kit - Cotton Filter 75-5028 - Manual (Page 2)

787 S. Wanamaker, Ontario, CA 91761 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbfilters.com
INSTALLATION INSTRUCTIONS (continued)
10.
Install the Battery Tray (N) , two M8 tapered
screws (O) and washers (M) on bottom, and the two
OE bolts on the inner fender side. Leave the tray
loose to help with air box and tube alignment.
NOTE: It maybe necessary to pre-thread the battery
tray with OE battery clamp bolt prior to battery
installation.
14.
Attach the Cold Air Tube (L) to the Air
Box (P) . Secure using the 5/16”x1” bolt (F) ,
Washer (H) , and Lock Washer (G) .
18.
Center the Hump Adapter (K) over the
gap between the turbo inlet and the Intake
Tube Adapter
(J) , secure both #64 Hose
Clamps (E) .
11.
Insert the Grommet (I) into the 5/8” hole
in the Air Box (P) .
15.
Slip the Hump Adapter (K) along with
two #64 hose clamps (E) , over the Intake
Tube Adapter (J) until flush with the end.
19.
Reconnect the air temp. sensor
electrical connection now if the OE pig tail
was too short during Step #17.
12.
Remove the air temp. sensor from the
OE connector and insert it into the Grommet
(I) that is now in the air box.
16.
Install the air box assembly, align the two
holes in the Air Box (P) with the corresponding holes
in the Battery Tray (N) . Secure the box to the tray
using the 5/16” x 3/4” Allen Head Screws (F) from
the outside, Washers (H), and Lock Nuts (Q) on the
inside of the box.
20.
Install the Air Filter (D) , secure the #64
Hose Clamp (E) .
13.
Attach the Intake Tube Adapter (J) to
the Air Box (P) . Secure using the 5/16”x1”
bolts (F) and Washers (H) .
17.
If the OE pig tail connector for the temp.
sensor is long enough, reconnect to the
sensor before the box is secured to the tray
as it will be easier to get to.
21.
Secure the battery tray to the vehicle
then reinstall and align the battery. Secure
using the OE battery clamp. NOTE: See note
at Step #10.
SEE EXPLODED VIEW ON PAGE 4
2
P/N: 75-5028 / 75-5028D
Pre-thread this hole