Installation instructions (continued) p/n: as-1006, Reminder – S&B Filters Cold Air Intake Scoop AS-1006 User Manual
Page 3
15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 -
INSTALLATION INSTRUCTIONS (continued)
P/N: AS-1006
SEE EXPLODED VIEW ON PAGE 4
3
12.
Reconnect the negative battery terminal.
Inspect the installation, be sure the kit is
properly positioned and all fasteners are
secure.
11.
Check to make sure the Scoop assembly
does not interfere with the wheel or wheel
well liner. Turn the wheel in both directions
while trying to simulate full suspension travel.
Make sure all connections are secure.
10.
Attach the Mounting Bracket
(B)
onto
the bumper mounting stud. When you are
satisfied with the position, tighten the OE nut
using a 18mm socket.
Precision II
Filter Cleaning & Oiling
Order online today at
through your local S&B distributor.
Part #: 88-0008
Testing and Maintenance
• Engage parking brake and start your engine.
Listen for abnormal noises. If an air leak is
detected, re-inspect hoses and connections as
they may need to be repositioned and tightened.
• S&B FILTERS recommends that you keep
your OE intake system in the event it is
required in the future.
• In order to maintain your warranty, all connections
and components must be checked periodically for
alignment and for proper tension on all
connections. Failure to do so may void your
warranty.
• Use only S&B FILTERS cleaning and oil products
to service your filter. Using any other brand oil
and or cleaners on your S&B air filter will void
your warranty.
Air Filter Wrap
Use with Oiled or Dry Filters
Order online today at
through your local S&B distributor.
Part #: WF-1034
Scoop Obstruction:
Regularly inspect the entire Scoop Inlet for any obstruction or debris that may impede the flow of air.
Ride Height
Once the Scoop has been installed, make sure there is plenty space between your tire and the scoop before driving.
The scoop system may not work with aftermarket wheels and tires.
REMINDER!
Water Ingestion Disclaimer:
This product is intended for general highway use only! Under normal driving conditions water ingestion is usually not
an issue; however, if the product becomes submerged from rain splashes or mud puddles due to harsh rains or
flooding the engine may ingest water which could cause severe engine damage. Do NOT use this product when
crossing any body of water including but not limited to large puddles, streams, rivers or lakes.
If your engine ingests water, this could cause severe engine damage by hydro-lock or other conditions. Care should be
taken to avoid these driving conditions. ENGINE DAMAGE CAUSED BY THE INGESTION OF WATER INTO THE
ENGINE IS THE DRIVER’S RESPONSIBILITY AND IS NOT COVERED BY S&B FILTERS!