S&B Filters Cold Air Intake Kit - Cotton Filter 75-5073 - Manual (Page 2)

15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbfilters.com
INSTALLATION INSTRUCTIONS (continued)
14.
Slide the 2 #72 Hose clamps (H) over
the Hump Adapter (G) . Then push the Hump
adapter (G) over the Adapter tube (K) . Leave
clamps loose for now.
19.
Install the Intake tube assembly by
sliding the breather hose over the steel tube
on the truck. Then push the silicone adapter
over the turbo inlet. Leave loose for now.
10.
Slide the Breather hose over the spout
on the Intake tube (C) . Slide both #12 Hose
clamps (X) over the hose and tighten the
clamp on the spout.
11.
Place the Adapter tube (K) into the
base of the S&B Air Filter (J) and tighten the
#88 Hose clamp.
20.
Make sure the Intake tube (C) and
Adapter tube (K) are aligned up top and
tighten the hose clamp at the turbo
connection. Also tighten the hose clamp at
the crankcase breather connection.
12.
Use the remaining 8-32 SS Screw
(F) and IAT Sensor Gasket (D) , and install the
IAT sensor into Adapter Tube (K) .
21.
Slide the Hump Adapter (G) over the
Intake tube (C) and secure both the #72 Hose
Clamps (H) .
SEE EXPLODED VIEW ON PAGE 4
2
P/N: 75-5073 / 75-5073D
18.
Carefully place the filter assembly into
the Air Box trying not to ding or gouge the
wire mesh. Rotate the Filter Adapter
assembly into position and hook the clip into
the Air Box.
15.
Attach the Splash Guard (V) to the Air
Box (Q) , use the supplied hardware to
secure as instructed in the exploded
view.
16.
Apply a light amount of grease to the
two prongs on the bottom of the box (Q)
before installing the Air Box assembly into the
vehicle.
17.
Attach the Air Box (Q) using the stock
nut removed in Step #5. Leave loose at this
time, it will be tightened in step #24.
22.
Reconnect the MAF sensor and IAT
sensor wiring harnesses to the sensors. It
may be necessary to remove the wire tie to
get more slack in the wires.