S&B Filters Cold Air Intake Kit - Cotton Filter 75-2524 - Manual (Page 2)

1/23/2008
(909) 947-0015 Telephone (909) 947-0603 Fax
www.sbfilters.com
INSTALLATION INSTRUCTIONS
(continued)
23. Connect the idle air line to the large con-
nector port on the side of the S&B intake
tube. Tighten clamp.
19. On vehicles that CONTAIN an external air
temperature sensor remove it from the
OEM tube and drill a 11/16” hole at the drill
point shown below. If your vehicle does not
contain an external air temperature sensor,
skip to step 20.
24. Connect the short provided hose to the
small connector port on tube. Connect
the line to the vent hose using the
hose connector provided.
19. a. Insert grommet into hole and then
insert temperature sensor as shown
below.
25. Reattach the electrical connection for
the primary mass air sensor.
20. Install the connector hose that has the
hump on air intake tube. Tighten hose
clamp around tube.
26. Reconnect wires to the vehicles base
connection.
21. Install heat shield with 5/16-18 screws
and washers.
27. Reattach the secondary electrical con-
nection. Then reconnect the retaining clip
to the fender.
22
. Attach intake tube to throttle body and
tighten clamps.
28. If your vehicle had an external tempera-
ture sensor and reconnect the electrical
connection now.
PERFORMANCE TESTING
1. Engage parking brake and start your engine.
To ensure that the system was installed prop-
erly, listen for abnormal noises. If an air leak is
detected, re-inspect hoses and connections
as they may need to be tightened.
2.
S&B FILTERS RECOMMENDS THAT YOU
KEEP YOUR OEM INTAKE SYSTEM IN THE
EVENT IT IS REQUIRED IN THE FUTURE.
3.
In order to maintain proper warranty, all con-
nections and components must be checked
periodically for realignment and to tighten all
connections. Failure to do so will void your
warranty.
4.
Use only S&B Cleaning and Oil Products to
service your filter. Using other company’s oil
and cleaner products may void your warranty.
Please call (909) 947-0015
should you have any ques-
tions or comments.
29. Install filter and align clamp so that it
can be tightened with a screwdriver as
shown in the picture below.
COMPLETED ASSEMBLY PICTURE
18. Assemble filter adapter and mass air sen-
sor using 1/4”-20 x 1” bolts and gaskets.
Also install connector hose to mass air
sensor and tighten clamp.
17. Remove the bolts that mount the mass
air sensor to the base plate.
Drill Point