S&B Filters Cold Air Intake Kit - Cotton Filter 75-5025 - Manual

1. With the ignition switched off and the
parking brake set, disconnect the negative
battery cable.
INSTALLATION INSTRUCTIONS
VEHICLE APPLICATION
Year: 2007-11
Make: Jeep Wrangler
Model:
Unlimited X, Sahara, Rubicon
Engine: 3.8L V6
TOOLS REQUIRED
• 10mm Wrench or Socket
• Phillips head Screwdriver
• 5/16” Nut Driver or Flat Blade Screwdriver
S&B FILTER OIL
Your Air Filter P/N: KF-1038 is factory oiled and
ready to use. When serviced it will require:
37g - Main Body
4g - Power Stack (Top)
NOTES
Kit may not fit with the following
Aftermarket Parts Installed:
• Body Lift
• Custom Hood
• Throttle Body Upgrade
• Throttle Body Spacer
BEFORE YOU START
• Please read the entire product guide before proceeding.
• Ensure all components listed on page 4 are present.
• If you are missing any of the components, call our customer support at (909) 947-0015.
• Do not attempt to work on your vehicle while engine is hot.
• Make sure the engine is turned off and the vehicle is in Park or the Parking Brake is set.
15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbfilters.com
4.
Unclip the air box lid and remove the lid
and tube assembly from the vehicle.
7.
Remove the bolt from the OE air box
tray. These will be reused with the S&B air
box.
2.
Disconnect the electrical connection for
the air temp. sensor in the OE intake tube.
5.
Pull up on the OE air box to remove it
from the vehicle, you will need to dislodge the
barbed prongs on the bottom side.
8.
Place the Air Box (A) in the vehicle, insert
prongs into the OE grommets and push the
box downward to seat the prongs.
3.
Loosen the hose clamp at the throttle
body and then disconnect the crankcase vent
line at the air box.
6.
All 3 grommets should have remained in
the OE air box tray, if not, replace them.
9.
Use the OE bolt removed in Step #7 to
secure the Air Box (A) to the vehicle.
P/N: 75-5025 / 75-5025D
SEE EXPLODED VIEW ON PAGE 4
1