Not for reproduction – Brute 2800 PSI Pressure Washer User Manual

Page 16

Advertising
background image

16

www.brutepower.com

Pressure Washer Rinsing

For Rinsing:

1. Remove black detergent spray tip from nozzle

extension.

2. Select and install desired high pressure spray tip

following instructions How to Use Spray Tips.

3. Keep the spray gun a safe distance from the area you

plan to spray.

4. Apply a high pressure spray to a small area, then check

the surface for damage. If no damage is found, it is
okay to continue cleaning.

5. Start at the top of the area to be rinsed, working down

with same overlapping strokes as you used for washing
and applying detergent.

Cleaning Detergent Siphoning Tube

If you used the detergent siphoning tube, you must flush it
with clean water before stopping the engine.

1. Place detergent siphoning tube in a bucket full of clean

water.

2. Remove high pressure spray tip from nozzle extension.
3. Select and install black detergent spray tip following

instructions How to Use Spray Tips.

4. Flush for 1-2 minutes.
5. Shut off engine following instructions How to Stop

Pressure Washer

and turn off water supply.

6. ALWAYS point gun in a safe direction and press red

button and squeeze spray gun trigger to release
retained high water pressure.

Automatic Cool Down System (Thermal Relief)

If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures above
125°F. The system engages to cool the pump by discharging
the warm water onto the ground.

WARNING The high pressure stream of water that

this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.

Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which could result in
serious injury.

• Keep high pressure hose connected to pump and spray gun

while system is pressurized.

• ALWAYS point spray gun in safe direction, press red button

and squeeze spray gun trigger to release high pressure, every
time you stop engine.

WARNING Kickback from spray gun could cause you

to fall resulting in death or serious injury.

• Operate pressure washer from a stable surface.

• Be extremely careful if you must use the pressure washer from

a ladder, scaffolding, or any other similar location.

• Firmly grasp spray gun with both hands when using high

pressure spray to avoid injury when spray gun kicks back.

Not

for

Reproduction

Advertising