Not for reproduction, Troubleshooting – Brute 2800 PSI Pressure Washer User Manual

Page 23

Advertising
background image

23

Troubleshooting

Problem

Cause

Correction

Pump has following problems:
failure to produce pressure, erratic
pressure, chattering, loss of pressure,
low water volume.

1. Low pressure spray tip installed.

2. Water inlet is blocked.
3. Inadequate water supply.
4. Inlet hose is kinked or leaking.
5. Clogged inlet hose screen.
6. Water supply is over 100°F (38°C).
7. High pressure hose is blocked or

leaks.

8. Spray gun leaks.
9. Spray tip is obstructed.

10. Pump is faulty.

1. Replace with high pressure spray

tip.

2. Clear inlet.
3. Provide adequate water flow.
4. Straighten inlet hose, patch leak.
5. Check and clean inlet hose screen.
6. Provide cooler water supply.
7. Clear blocks in outlet hose.

8. Replace spray gun.
9. Clean spray tip.

10. Contact local service facility.

Detergent fails to mix with spray.

1. Detergent siphoning tube is not

submerged.

2. Detergent siphoning tube is

clogged or cracked.

3. High pressure spray tip installed.

4. Check ball stuck in detergent

siphoning system.

1. Insert detergent siphoning tube into

detergent.

2. Clean or replace detergent

siphoning tube.

3. Replace with low pressure spray

tip.

4. Unstick check ball as described in

Detergent Siphoning Check Ball

.

Engine runs good at no-load but "bogs"
when load is added.

Engine speed is too slow.

Move throttle control to FAST position. If
engine still "bogs down", contact local
service facility.

Engine will not start; shuts down during
operation or starts and runs rough.

1. Low oil level.
2. Dirty air cleaner.
3. Out of fuel.
4. Stale fuel.
5. Spark plug wire not connected to

spark plug.

6. Bad spark plug.
7. Water in fuel.
8. Excessively rich fuel mixture.

1. Fill crankcase to proper level.
2. Clean or replace air cleaner.
3. Fill fuel tank.
4. Drain fuel tank; fill with fresh fuel.
5. Connect wire to spark plug.

6. Replace spark plug.
7. Drain fuel tank; fill with fresh fuel.
8. Contact local service facility.

Engine lacks power.

Dirty air filter.

Replace air filter.

Not

for

Reproduction

Advertising