Dowco Power Sports Guardian Trailerable ATV Cover - Manual (Page 2)

#00347-00
Page 2
Revised 4/14/04
Trailerable ATV Cover
4230 Clipper Dr. Manitowoc WI. 54220 U.S.A
Phone: (800) 558-7755 - Fax (920) 682-5891 - Email: [email protected]
Visit our web-site! - www.dowco-inc.com
Make any further adjustments necessary so that the cover is pulled evenly over the ATV.
Included with the ATV cover is 1 long, and 2 short web straps, each with 2 side-release buckles (male ends).
Use the long strap and join the side-release buckle (pictured at top middle) at the rear between the back tires.
Then pull the web strap to the front between the front tires and join the side release buckle there. Pull the
loose strap to tighten. Note- None of the “slack straps” (below) should be tightened (as pictured) at this time!
Now use both short straps for the bottom sides of the cover, between the front and rear
axles. Join the side release buckles on opposite sides in a “criss-cross” manner (illustrated
at right). Pull the loose web straps to tighten.
Additionally, there are hook and loop secured flaps at each corner of the cover. These flaps are a feature that
allow for tie-down straps to be attached to the ATV and fastened to the trailer while trailering.
Finally, the numerous straps, or “slack” straps, located along the top (pictured above left) and other areas of
the cover must be tightened to eliminate “slack” or loose material from the cover. To tighten (A) pull the
loose strap (B) until snug. To loosen (C) simply lift up on the clip in the opposite direction from which it was
tightened.
BACK FRONT
A
C
B
SECURING THE COVER:
5.
6.
7.