Dexter Laundry T-50 (On-Premise) - Manual (Page 13)

- -
13
PROGRAMMING INSTRUCTIONS:
(To switch to program mode.)
1. Unlock the upper service door and raise it until it can
be held in place by the pivoting wire support.
2. Open the loading door and leave open.
3. Push the Program Button found between the service
panel and the board. (Follow arrow on label)
4. Lower the upper service door to view the membrane
switch keypad.
5. The control changes to PROGRAM mode. In
PROGRAM mode, the membrane switch keypad
becomes a 4-switch programming tool.
6. The ACTUAL NUMERICAL VALUES desired are keyed in
as explained on page 14.
IMPORTANT: Please, remember to push "Start" to actually enter (store in memory) new data. If you
merely change the display, memory hasn’t yet been changed -- only "Start" will actually change the
memory!
DISPLAY
ANNUNCIATOR LIGHTS WHICH HELP
IDENTIFY PROGRAMMING STEPS
INCREASES DISPLAYED VALUES
DECREASES DISPLAYED VALUES
ZEROS HOUR METER ON STEP 1
ZEROS LEFT COIN COUNT ON STEP 2
ZEROS RIGHT COIN COUNT ON STEP 3
RESTORES ORIGINAL VALUE ON STEPS
4 TO 18
Stores the displayed value in memory
and advances the controller to the
next programming step.
LAST TEMP
JUMPER
ANTI-
WRINKLE
JUMPER