Dexter Laundry T-50 (On-Premise) - Manual (Page 17)

- -
17
PREVENTIVE MAINTENANCE INSTRUCTIONS
DAILY
1. Clean the lint screen. Use a soft brush if necessary.
2. Check the lint screen for tears. Replace if necessary.
3. Clean lint from the lint screen compartment.
MONTHLY
1. Remove lint accumulation from the end bells of the motor.
2. Remove lint accumulation from front control area.
3. Remove lint and dirt accumulation from the top of the dryer and all areas above, below, and around the
burners and burner housing. Failure to keep this portion of the dryer clean can lead to a build-up of lint
creating a fire hazard.
4. Place a few drops of light oil on the clothes door hinge.
5. Grease the bearings and the shaft of the intermediate drive pulley. Use an Alemite grease gun and
Molykote BR2-S grease.
QUARTERLY
1. Check the belts for looseness, wear, or fraying.
2. Inspect the gasket of the door glass for excessive wear.
3. Check tightness of all fasteners holding parts to support channel.
4. Check tightness of all set screws.
5. Inspect the impeller for tightness of the blades to hub.
6. Check the tightness of the tumbler shaft retaining bolt.
7. Remove the air flow switch assembly and check the tumbler thru-bolts for tightness.
8. Remove lint accumulation from the primary air ports in the burners.
9. Apply a few drops of oil to each spacer tube on the tension arm assembly.
10. Grease the pivot pins and the tension arms where in contact with each other.
SEMI - ANNUALLY
1. Remove and clean the main burners.
2. Remove all orifices and examine for dirt and hole obstruction.
3. Remove all lint accumulation. Remove the front panel and the lint screen housing and remove lint
accumulation.
ANNUALLY
1. Check the intermediate pulley bearings for wear.
2. Check and remove any lint accumulation from the exhaust system.
SERVICE PARTS ____________ PART NUMBER ______________
DCBD30KC-10/39 DCBD50KC-10/39 DCBD80KC-10/39
DRIVE BELT, MOTOR 9040-076-003 9040-076-006 9040-076-011
DRIVE BELT, TUMBLER 9040-073-009 9040-073-011 9040-073-012
LINT SCREEN FILTER 9822-026-002 9822-026-001 9822-031-002
For service and parts information, contact your local Dexter agent. To find your local Dexter agent, use the
Distributor Locator at the website shown below. If a Dexter agent is not available, contact Dexter Laundry,
Inc. directly as listed below:
Mailing Address: 2211 West Grimes Avenue Phone: 1-800-524-2954
Fairfield, IA 52556
USA
Website:
www.dexterlaundry.com