Factory Direct Hardware Hansgrohe 10050 - Manual

08/2004
HANSGROHE PRODUCT SERVICE
TWO HANDLE LAV MIXER
TWO HANDLE HIGHRISER
TWO HANDLE BIDET MIXER
Ref. No.: 10030XX1/10050XX1/
10058XX1/10230XX1
Installation
Starck
Assembly
1. Flush pipe lines thoroughly.
2. Place the mixer including the sealing washer in position on the basin / bidet.
3. Slip the slide washer, washer and collar nut over the threaded base and tighten the collar nut by hand.
4. Tighten screws.
5. Connect the supply pipes to the supply valves: hot-left; cold-right.
6. Connect the lift rod to the pop-up waste assembly (only 10030XX1, 10050XX1 and 10230XX1).
Large differences in pressure between the hot and cold water supply should be balanced.
Technical data
Operating pressure : max. 147 psi
Recommended operating press. : 14.7 - 72.5 psi
Test pressure : 232 psi
Hot water temperature : max. 176° F
Recommended hot water temp. : 149° F
Hole size in deck:
Minimum: 1 1/4"
Maximum: 1 5/8"
Lav Mixer 10030XX1 Bidet Mixer 10230XX1
Highriser 10050XX1
Highriser 10058XX1 without lift rod and
pop-up waste
Mounting
max. 1¾"
hot cold