Ocean Optics NeoFox Engineering Note - Manual (Page 20)

NeoFox Communication Interfaces
20 013-20000-010-04-201211
Multi Point Orig C0 Float n/a 206 232
NEOFOX_CAL_MULTI_C0 DeviceSetParameterFloat DeviceGetParameterFloat
This is a Multi Point calibration parameter. See the
NeoFox Calibration and Measurement engineering note and the
NeoFox manual for more information about this parameter.
Multi Point Orig C1
Float n/a 207 236
NEOFOX_CAL_MULTI_C1 DeviceSetParameterFloat DeviceGetParameterFloat
This is a Multi Point calibration parameter. See the
NeoFox Calibration and Measurement and the NeoFox manual for
more information about this parameter.
Multi Point Orig C2
Float n/a 208 240
NEOFOX_CAL_MULTI_C2 DeviceSetParameterFloat DeviceGetParameterFloat
This is a Multi Point calibration parameter. See the
NeoFox Calibration and Measurement engineering note and the
NeoFox manual for more information about this parameter.
Multi Point Orig T0
Float n/a 209 244
NEOFOX_CAL_MULTI_T0 DeviceSetParameterFloat DeviceGetParameterFloat
This is a Multi Point calibration parameter. See the
NeoFox Calibration and Measurement engineering note and the
NeoFox manual for more information about this parameter.
Multi Point OrigT1
Float n/a 210 248
NEOFOX_CAL_MULTI_T1 DeviceSetParameterFloat DeviceGetParameterFloat
This is a Multi Point calibration parameter. See the
NeoFox Calibration and Measurement engineering note and the
NeoFox manual for more information about this parameter.
Multi Point Orig T2 Float n/a 211 252
NEOFOX_CAL_MULTI_T2 DeviceSetParameterFloat DeviceGetParameterFloat
This is a Multi Point calibration parameter. See the
NeoFox Calibration and Measurement engineering note and the
NeoFox manual for more information about this parameter.
Multi Point SP A0
Float n/a 256
n/a n/a n/a
This is a Single Point calibration parameter. It is a copy of its counterpart from the multi-point calibration parameter
that is copied during a single point reset. It cannot be read or set through DLL function calls. It also cannot be set
through the serial protocol, but it can be read. See the
NeoFox Calibration and Measurement engineering note and the
NeoFox manual for more information about this parameter.
Multi Point SP A1
Float n/a 260
n/a n/a n/a
This is a Single Point calibration parameter. It is a copy of its counterpart from the multi-point calibration parameter
that is copied during a single point reset. It cannot be read or set through DLL function calls. It also cannot be set
through the serial protocol, but it can be read. See the
NeoFox Calibration and Measurement engineering note and the
NeoFox manual for more information about this parameter.