Ocean Optics RaySphere 1700 Install - Manual (Page 18)

2: Installation and Setup
8 RAYSPHERE-1700-02-201304
Note
If the following screen appears during the installation, select Repair:
6. Click Close when the installation is completed. It is not necessary to restart your computer.
Assembling RaySphere
Follow the steps below to set up your RaySphere for use.
► Procedure
1. Connect the power cable to the power supply.
2. Connect the RaySphere unit to the power supply with the SubD cable.
3. Switch on the power supply.
4. Connect the RaySphere to your computer using a USB cable.
Caution
Be sure to switch on the power supply before connecting the RaySphere to your computer.
Your RaySphere is now ready to use after 20 minutes of warm-up time.