SENA Parani-SD1000 - Manual (Page 55)

55
C.31. S59: Current Slave in Communication (default 0)
This value shows the current slave number in communication. The value is automatically stored when
the slave is selected for communication. This value can also be set by user so the master unit
connects to a specific slave to connect first in case the master unit reboots. The value range is 0~4. 0
means the maser unit never connected to a slave. The master will connect to a slave whatever
responses first.
C.32. S60: Reconnect Time Interval (default 5)
This value defines reconnect time interval in case a slave is disconnected in multiple connection mode.
The actual reconnect time interval will be the value multiplied by two in seconds. For example, if the
value is set to 5, the reconnect time interval will be 10 seconds. The value should be greater than or
equal to 5. The master unit will only try to reconnect when its mode is set to Mode1.
C.33. S62: Sleep IC (default 0)
This value decides whether the Sleep IC's on/off when there is no data transmission. The Sleep IC
function is used for low consuming power. (This function is supported only for the products whose
original firmware version is v2.0.1 or later. Even though the products whose original firmware version
is earlier than v2.0.1 is upgraded to v2.0.1 or later, they are not allowed to control the on/off status of
Sleep IC.)
S62=0, The line driver will be always wake up (Sleep IC function off).
S62=1, The line driver will be sleeping during no data transmission. (Sleep IC function on)