SENA Parani-ESD100V2-110V2 - Manual (Page 9)

9
2. Getting Started
This chapter describes how to set up the Parani-ESD for the first time.
- 2.1 Panel Layout explains the panel layout.
- 2.2 Connecting the Hardware describes how to connect the Parani-ESD, the power, and the serial
device to the Jig Board.
Following items are pre-required to get started.
- One Jig Board (included in the Starter Kit package).
- One DC power adapter or one USB power cable (included in the Starter Kit package).
- One serial console cable for configuration (included in the Starter Kit package).
- One PC with RS232 serial port.
- Terminal emulation program running on the PC
2.1. Panel Layout
This section describes the panel layout of the Development Board.
Figure 2-1 The Panel Layout of Development Board
2.2. Connecting the Hardware
This section describes how to connect the Parani-ESD to the Development Board and the
Development Board to the serial device for initial testing.
- Connect the Parani-ESD to the Development Board.
- Connect a power source to the Development Board for the Parani-ESD.
- Connect the Development Board for the Parani-ESD to a serial device.