SENA Parani-MSP1000 - Manual (Page 54)

54
7.6.1 Manual firmware upgrade
To upgrade firmware via the web:
1. Select the latest firmware binary by clicking browse button.
2. Select and upload the selected version.
3. Once the upgrade has been completed, the system will reboot to apply the changes.
Figure 7-7 Firmware upgrade
To use either a remote or serial console to upgrade your firmware, the TELENT/SSH or terminal
emulation program must support Zmodem transfer protocol. The previous settings will be retained
after the firmware upgrade.
To upgrade firmware via a remote console:
1. Obtain the latest firmware.
2. Connect the terminal emulation program using either TELENT/SSH or a serial console
port.
(TELNET or SSH is recommended since the process of firmware upgrade by serial
console requires extremely long time.)
3. Select from the firmware upgrade menu as shown in
-------------------------------------------------------------------------------
Welcome to MSP1000 configuration page
Current Time
: 8/26/2007 06:55:14 Serial No. : MSP1000-00001
F/W Rev. : v1.0.0 MAC Addr.(eth0) : 00:01:95:AF:BE:11
IP Mode (eth0) : Static IP Addr.(eth0) : 192.168.11.30
-------------------------------------------------------------------------------
1. Network configuration
2. System administration
3. System status & log
4. CF card configuration
5. Monitoring
6. Save changes
7. Exit without saving
8. Exit and apply changes
9. Exit and reboot
<ESC> Back, <ENTER> Refresh
--> 2