Billet Specialties Premium Tru Trac Serpentine System - Big Block Chevy - Manual (Page 10)

www.billetspecialties.com www.billetspecialties.com
19
Figure 14: Install Serpentine Belt & Tensioner Pulley
A] Route belt as shown minus tensioner pulley.
B] Place a 5/8” box end wrench on tensioner, align belt onto grove of
tensioner pulley.
C] Pull up on wrench until tensioner pulley hole lines up with boss on ten-
sioner, slide pulley onto boss and slowly lower wrench to apply tension to
serpentine belt.
D] Apply anti-seize to the threads of the 3/8-16 x 3/4” ARP 12pt. cap
screw and thread it through the aluminum washer into tensioner boss and
tighten firmly (46 ft/lbs.).
Figure 15: Install Manifold Hose Block
Attach the compressor manifold. The manifold attaches to the
compressor in place of the block-off plate using two 8mm-1.25 x 25mm
socket head cap screws. Apply anti-seize to threads before installing.
IMPORTANT
• Only remove sealed cap on compressor if you plan on charging your
A/C system immediately, leaving the compressor open to outside air
can introduce moisture into the system causing the cooling system to not
operate properly.
• Never connect the compressor clutch wire and run the compressor
unless the system is charged. Serious damage may occur to compressor.
COMPRESSOR OIL
•Although the compressor is supplied with oil, the level may not be
correct for the entire system. Consult the instruction manual of the air
conditioning unit for proper levels and system charging procedures.
• Billet Specialties recommends having your air conditioning charged
and serviced by an automotive air conditioning service center with the
proper equipment to ensure many years of trouble free operation.
B
C
D
A