Billet Specialties Premium Tru Trac Serpentine System - Big Block Chevy - Manual (Page 4)

www.billetspecialties.com www.billetspecialties.com
7
Figure 1: Installing Mounting Studs
Apply RTV silicone to one end of the four 3/8-16 x 3" threaded studs.
A] Use the two included 3/8-16 nuts (zinc plated) tightened against each
other to act as a drive nut to ease installation (see illustration below).
B] Seat studs firmly into block.
Figure 2: Install O-Rings & Compressor Bracket
A] The a/c compressor and alternator mounting brackets incorporate
o-rings on both sides for sealing.
B] Slide the a/c compressor bracket onto the water pump studs on
passenger side of block and seat against block.
C] Apply anti-seize to the 7/16-14 x 1-1/4” socket head cap screw and
thread the bolt through the compressor bracket and into the block.
* GEN. VI BLOCK *
For Generation VI blocks without a fuel pump
boss, you will need to install the 3/8-16 x 1"
hex head flange bolt (shown on page 11)
through the compressor bracket at this time.
Example
A
B
C
A
B