SCANTECH ID (Champtek company) V-1040BT - Manual (Page 16)

8
ATTENTION
The V-1040BT scanner must be charged for a
minimum of 8 hours before the scanner can be
placed in full operation for the first time.
The scanner LED will indicate in red when the
scanner is charged.
After the battery is full, the green LED on
scanner will be on. The charge green LED will be
off when the scanner leaving from cradle.
If the battery power of the V-1040BT is too low,
the V-1040BT will indicate red LED and beeper
warning.
It is important to know that the V-1040BT scanner will
only communicate with the cradle whose unique Bluetooth
MAC address was last scanned.
If a cradle is paired with the V-1040BT scanner, another
V-1040BT scanner can’t be paired with that cradle until
the original connection is interrupted.
If you pair a second V-1040BT scanner to an in-use cradle,
the cradle’s connection to the first V-1040BT scanner
will be interrupted and the connection will be re-
established with the second V-1040BT scanner.
Bluetooth MAC
Address