SCANTECH ID (Champtek company) V-1040BT - Manual (Page 5)

4.8.3 Parity .................................. 22
4.8.4 Handshaking ............................. 23
4.9 Keyboard Wedge Mode Parameters .......... 24
4.9.1 Terminal Type ........................... 24
4.9.2 Country/Language ........................ 25
4.9.3 Upper/Lower Case ........................ 26
4.9.4 Capslock Detection ...................... 26
4.9.5 Character by ALT Method ................. 27
4.9.6 Select Numerical Pad .................... 27
4.9.7 Interscan Code Delay .................... 27
4.10 Output Characters ....................... 28
4.10.1 Select Terminator ....................... 28
4.11 Code Type ............................... 29
4.11.1 Barcode Selection ....................... 29
4.12 UPC/EAN/JAN Parameters .................. 32
4.12.1 Reading Type ............................ 32
4.12.2 Supplemental Setup ...................... 34
4.12.3 Check Digit Transmission ................ 34
4.13 Code 39 Parameters ...................... 35
4.13.1 Type of Code ............................ 35
4.13.2 Check Digit Transmission ................ 35
4.13.3 Output Start/Stop Character ............. 36
4.13.4 Decode Asterisk ......................... 36
4.13.5 Setup Code Length ....................... 36
4.14 Code 128 Parameters ..................... 38
4.14.1 Reading Type ............................ 38
4.14.2 Check Digit Transmission ................ 38
4.14.3 Append FNC2 ............................. 38