QTech Data Systems DNP3 RTU - Manual (Page 22)

DATRAN XL4 RTU – Owners Manual – v1.1 June 2012
www.qtech.co.nz Page 22
Analog I/O Configuration Jumpers Analog I/O Configuration Jumpers Analog I/O Configuration Jumpers Analog I/O Configuration Jumpers
The analog input configuration jumpers are located at the top right region of the Q22 when viewed with the Q24 on
the right and the Q04 Processor board removed. The square pad on each jumper header is indicates pin 1. The
pins are numbered 1, 2, and 3 away from pin 1.
Analog input configuration jumpers.
The following tables show the jumper configurations of analog channel when configured as Single Ended Inputs.
Channel No 1 – Single Ended Input
J7 J8 J21
0..5V 2 - 3 OPEN INSTALL
0..10V 1 - 2 2 - 3 INSTALL
0..20mA 2 - 3 1 - 2 INSTALL
Channel No 2 – Single Ended Input
J5 J6 J17
0..5V 2 - 3 OPEN 2 - 3
0..10V 1 - 2 2 - 3 2 - 3
0..20mA 2 - 3 1 - 2 2 - 3
Channel No 3 – Single Ended Input
J9 J10 J22
0..5V 2 - 3 OPEN INSTALL
0..10V 1 - 2 2 - 3 INSTALL
0..20mA 2 - 3 1 - 2 INSTALL
Channel No 4 – Single Ended Input
J11 J12 J18
0..5V 2 - 3 OPEN 2 - 3
0..10V 1 - 2 2 - 3 2 - 3
0..20mA 2 - 3 1 - 2 2 - 3
Channel No 5 – Single Ended Input
J13 J14 J19
0..5V 2 - 3 OPEN 2 - 3
0..10V 1 - 2 2 - 3 2 - 3
0..20mA 2 - 3 1 - 2 2 - 3
Channel No 6 – Single Ended Input
J15 J16 J20
0..5V 2 - 3 OPEN 2 - 3
0..10V 1 - 2 2 - 3 2 - 3
0..20mA 2 - 3 1 - 2 2 - 3
The following tables show the jumper settings for configuring analog input channels 1 & 2 and/or 3 & 4 as
Differential Input channels: -