QTech Data Systems DNP3 RTU - Manual (Page 32)

DATRAN XL4 RTU – Owners Manual – v1.1 June 2012
www.qtech.co.nz Page 32
WARRANTY & LIABIL WARRANTY & LIABIL WARRANTY & LIABIL WARRANTY & LIABILITY ITY ITY ITY
Subject to the under mentioned exemptions QTech Data Systems Limited undertakes to repair any manufacturing
defects and replace or repair any faulty materials within (12) twelve months from the date of sale to the original
purchaser.
The exemptions referred to are:
1) Fair wear and tear
2 Faulty installation, misuse, neglect, accident and similar causes.
3) Equipment that does not bear the original Serial Number label or the label has been defaced or altered.
4) Unsuitable operating conditions, including improper installation and other influences beyond QTech
control.
5) Alterations carried out by the Purchaser or any unauthorised third party.
7) Power supply protection parts, including fuses and other circuitry provided to protect the unit from electrical
damage.
8) Output drivers, transistors, relays and other parts of the circuitry that are directly connected to third party
equipment.
9) Damage resulting from lightening strikes and other static discharges.
Liability for replacements supplied or repairs carried out is limited to the original (12) twelve month warranty period.
QTech will not accept responsibility for warranty work carried out by the purchaser or any unauthorised third party.
QTech does not assume or authorise any person to assume for QTech any other liability regarding its products.
QTech ’s liability is limited to the extent set out above and does not extend to any consequential damages or
losses.
DISCLAIMER DISCLAIMER DISCLAIMER DISCLAIMER
In no event shall QTech nor it respective agents be liable for special, direct, indirect, or consequential damages
losses, costs, charges, claims, demands, claims for loss of profit, fees, or expenses of any nature or kind.
While QTech warrants it’s products it does not imply a warranty for its use for a particular purpose.
QTech shall not be liable for any infringement or violation of copyright with respect to the material reproduced or
displayed on its products. .
WARRANTY SERVICE WARRANTY SERVICE WARRANTY SERVICE WARRANTY SERVICE
Where the conditions of liability as set out above are met QTech will carry out warranty service as detailed below:
1) Goods returned for servicing shall be adequately packaged to prevent damage in transit and shall be
forwarded freight pre-paid.
2) A description of the fault/s together with any other relevant information relating to the fault, together with
the return address to which the equipment is to be returned, must be included with any equipment returned
to
QTech for repair.
3) QTech may elect at its sole discretion to repair or replace equipment returned for repair.
4) Where repairs to the equipment are undertaken, the repairs will be undertaken during normal business
hours.
5) Once repairs or replacements are complete, the equipment will be returned by a suitable carrier to the
Purchaser unless otherwise instructed by the Purchaser.