Dayton Audio DTA-1AR Wireless Class T Digital Amp__Receiver 15 WPC User Manual

Page 2

background image

Power Output: 15 watts RMS x 2 into 4 ohms

Total Harmonic Distortion: 0.04% (9W @ 4 ohms)

Dynamic Range:

90 dB

Frequency Response:

20-20,000 Hz

Transmitting Frequency Range: 2.4 GHz (2400-2480 MHz)

Sample Rate:

44.1 KHz, 16-Bit

*Wireless Range: Up to 20 meters (66 ft.) line-of sight

(range may vary)

Electrical Requirements:
DTA-1AR (amplifier/receiver): 12 VDC, 2A
DTA-1T (transmitter): 9 VDC, 1A
Power supplies included, each unit may also use

8 AA batteries (sold separately)


2" H x 6-1/8" W x 3-3/8" D (both units)


2.2 lbs total, 1.1 lbs. each unit



1. Right speaker output
2. Power supply input
3. Stereo 3.5 mm AUX audio input
4. Left speaker output
5. Power on and volume control

For wireless use:
Connect your source to the 3.5 mm input
on the DTA-1T. Connect your speakers (4 or 8 ohms) to the
DTA-1AR. Connect power included power supplies to the
DTA-1T and DTA-1AR. Turn both units on. The DTA-1T will
indicate power on with a blue LED, while the DTA-1AR will
indicate power on and wireless sync to the DTA-1T with a
green LED.

For wired use: The DTA-1AR may also be used as a stand-
alone amplifier. Connect a local source is to the AUX input of
the DTA-1AR, the green LED will change from green to blue
and the local source will automatically override the wireless

Either volume control on the DTA-1T or DTA-1AR may be
used to control the volume level of the amplifier output.