Ak-50 & aks-50 draw-out breakers, Ak-75 & ak-100 draw-out breakers, Fourth-wire disconnect assembly for akd equipment – GE Industrial Solutions ProTrip Conversion Kits AK-50, AKU-50, AKS-50, AKT-50, AK-75, and AK-100 User Manual

Page 18

Text mode
Original mode

Advertising

Installing the Neutral Sensor

The neutral sensor is an electrical duplicate of the phase
sensor, including the taps. Therefore, when taps (if
provided) are changed on the phase sensors, the taps on
the neutral sensor must be similarly changed. For kits
with fixed phase sensors, be sure to use the
corresponding tap on the neutral sensor.

Mount the neutral sensor on the outgoing neutral lead,
normally in the equipment bus or cable compartment.
Figure 29 shows mounting details for the neutral sensor
for AK-50 breakers, while Figure 30 covers AK-75 and
AK-100 breakers.

Figure 29. Outline of the neutral sensor for AK-50 breakers.

Advertising