GE Industrial Solutions MicroVersaTrip Plus and MicroVersaTrip PM AK-1-15, AK-1-25 - Manual (Page 15)

15
4. Connect the flux shifter reset arm to the reset
stud using the X washer provided, as shown in
Figures 31 and 32.
CAUTION: Seven X washers are supplied with the
kit. One of the washers is smaller than the rest. The
smaller X washer is used for installing the flux
shifter reset arm.
NOTE: Figure 30 shows the installed flux shifter
assembly from the rear with the right pole assem-
bly removed from the breaker.
Figure 30. Flux shifter installed.
Figure 31. Installation of the flux shifter reset arm.
Figure 32. Attaching the X washer to secure the flux shifter reset
arm.
Reset
Arm