Programming, How to programme, Af-60 lp™ micro drive programming guide – GE Industrial Solutions AF-60 LP Micro Drive User Manual
Page 8
3. Programming
3.1. How to Programme
3.1.1. Programming with DCT-10 Set-up Software
The frequency converter can be programmed from a PC via RS485 com-port by installing the DCT-10 Set-up Software.
This software can be downloaded from the GE Web site: www.geelectrical.com/drives
3.1.2. Programming with the Keypad
The Keypad is divided into four functional groups:
1.
Numeric display.
2.
Menu key.
3.
Navigation keys.
4.
Operation keys and indicator lights (LEDs).
NB!
Parameters should be changed in numerical order. Certain parameter values are affected by preceding changes.
Illustration 3.1: Keypad with potentiometer
The display:
A number of information can be read from the display.
Set-up number
shows the active set-up and the edit set-up. If the same set-
up acts as both active and edit set-up, only that set-up number is shown
(factory setting).
When active and edit set-up differ, both numbers are shown in the display
(Setup 12). The number flashing, indicates the edit set-up.
Illustration 3.3: Indicating Set-up
AF-60 LP™ Micro Drive Programming Guide
7
3