GE Industrial Solutions Control System Toolbox For AV-300, DV-300, AV-300i (AVDV Series) Drives - Manual (Page 62)

4-32
•
Chapter 4 Configuring an AVDV Series Drive GEH-6405A Toolbox for an AVDV Series Drive
Choose the desired self-
from the drop-down
Click to Start the
self-tune test in
Click to Stop the self-tune
in process.
Click here after the self-
has completed.
This command takes the
Computed Values list
created from the self-
and copies them to the
Current Values list to be
used by the current
Click Close to end the
process (see note
Note: These values must
saved to non-volatile
From the Device menu,
choose Save Parameters.
The state of the self-
displays here.
Additional messages may display here as the self-tune
Click Start and the following caution displays. Click Yes to continue.
Note When you close the Self-tune dialog box, the following caution displays if
your Main Commands setting was switched to Digital in the first step above. Choose
OK to continue.