GE Industrial Solutions EntelliPro ES - Manual (Page 246)

EPOS MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL 6.11
CHAPTER 6: ENTELLIPRO CP3 and CP5 APPLICATION
6.5 EntelliPro CP5 Main panel
NOTE : If the drive typical value is set to “Fully free logic,” the Modbus data interface of the free logic must follow the EntelliPro
text, the device status, and the device condition, respectively.
the device configuration screen. The columns shows the Modbus address (MB), the Profibus-DP address (PB), the device
Each row in the root screen below shows information about one EntelliPro ES device. The row assignment must be done in
ES standard. Otherwise the data in the EntelliPro CP application might be incorrect.
CHAPTER 6: ENTELLIPRO CP3 and CP5 APPLICATION
DOL reverse, Star delta, Star delta reverse, Soft starter, Soft starter reverse, Dahlander, Pole changing starter, Solenoid valve,
The next two figures show the Entellipro CP5 main panel.
and Actuator
CHAPTER 6: ENTELLIPRO CP3 and CP5 APPLICATION
CHAPTER 6: ENTELLIPRO CP3 and CP5 APPLICATION
The EntelliPro CP5 device is a touch control display integrated into the Motor Control Center MCC for local control; alarm
N
OTE
:
The EntelliPro CP5 application has been created to opearte and handle the pre-programmed drive typical, such as DOL,
handling and visualization the device status, values, and parameter settings.
standa
r
Star Delta,
valve and Actuator.