1 important safety rules – GE Industrial Solutions ISM User Manual
Page 6
Modifications reserved
Page 6/34
OPM_ISM_OPT_10K_M50_0GB_V021.doc
Operating Manual ISM – Intelligent Synchronization Module
1.1 IMPORTANT SAFETY RULES
SAVE THESE INSTRUCTIONS
This manual contains important instructions for model ISM - Intelligent Synchronization Module that
should be followed during installation and maintenance of the unit.
GENERAL
•
Move the cabinet in a horizontal position in its original package to the final destination room.
•
To lift the cabinets, use a forklift or lifting belts with spreader bars.
•
Check for sufficient floor and elevator loading capacity.
•
Check carefully the integrity of the ISM equipment.
In case you note some visible damage, do not put the ISM under voltage, but contact the nearest
Service Centre.
•
WARNING! RISK OF ELECTRICAL SHOCK: Do not remove covers; there are no user serviceable parts
inside.
•
This unit contains potentially hazardous voltages.
•
All maintenance and service work should be performed by qualified service personnel.
INSTALLATION
•
This equipment must be installed and connected only by trained personnel.
•
This equipment is intended for use in a controlled indoor environment free of conductive
contaminants and protected against animals intrusion.
•
WARNING! HIGH EARTH LEAKAGE CURRENT: earth connection is essential before connecting to AC
input!
•
Do not install the equipment in an excessively humid environment or near water.
•
Avoid spilling liquids on or dropping any foreign object into the equipment.
•
The unit must be placed in a sufficiently ventilated area; the ambient temperature should not
exceed 35°C (95°F).
•
It is important that air can move freely around and through the unit.
•
Do not block the air vents.
•
Avoid locations in direct sunlight or near heat sources.
STORAGE
•
Store the equipment in a dry location; storage temperature must be within -25°C to 55°C
(-13°F to 131°F).
WARNING !
The installation and cabling of the options must be
performed by a QUALIFIED SERVICE PERSON.
Before operating be sure the installation is completely
switched off and voltage free